Well it's been a while! Thought I'd have a go at modding my front cable as I came up with a solution whilst building up BobK's new rig. The Nokon brake cables come with some plastic tubes which, I think, are to stop cable rattle & paint rub on frames which they are installed on? So the plastic tubes seem to have a good tight fit on normal brake cable outer so I figured I could finally do the cable join that I'd been waiting to do for ages. My reason for doing this mod was purely aesthetic in that I wanted orange cables originally but the Linear will not bend nicely for the brake end of the cable run so a normal piece is substituted for that end.
I cut the top half of the cable (linear) so that the join would run about mid way inside the fork steerer & then the standard outer would continue on to the front brake. I made sure that the 2 mating surface ends of the cables were nice & flat & the fit was nice & tight in the joining piece.
I cut the top half of the cable (linear) so that the join would run about mid way inside the fork steerer & then the standard outer would continue on to the front brake. I made sure that the 2 mating surface ends of the cables were nice & flat & the fit was nice & tight in the joining piece.
Once fitted it seems to work fine but I will reserve judgement until it's been through a good few sessions. Seeing as I haven't ridden since the RAD Xmas doo that may take a while!
No comments:
Post a Comment
Note: only a member of this blog may post a comment.